 |
One Piece Steel Drive Shaft, Made To Order For Toyota Supra MKII, MKIII or MKIV, Toyota Cressida, Lexus SC, IS or GS. (MKII, SC, GS, or MK4 require a diff adapter) We can even make driveshafts for Nissan and other import and domestic cars! Call us with any questions you may have! Transmissions with a fixed output flange will require a steel driveshaft with a slip yoke in the driveshaft itself.
For R154, W58, or A340 transmission. Replaces overweight 2 piece driveshaft, lowering rotating mass. Our 3" driveshafts use high quality Dana-Spicer 1310 Life Series u-joints that are maintenance free. We now have an option for 3.5" tubing for cars that have a driveshaft measurement over 54", or cars that will see very high speeds. This drive shaft is conservatively rated to 500 wheel horsepower.
We need you to measure from the end of the output shaft of the transmission to the face of the flange on the differential, and also the type of vehicle/transmission/differential information in the order notes!
If it has a rubber isolator on the diff, remove it before taking the measurement. Please see the 2nd and 3rd pic to see how to take the correct measurement. Please list these measurements, along with the model and year of the car and differential, and the type of transmission in the order notes. Please call if you are unsure about how to determine this information. Thanks!
The option to add a 3-4 bolt diff adapter is for GS/SC/MK4 vehicles that need a billet adapter for the differential flange. We have two sizes available, please measure your diff flange: The "Small Pattern" bolt holes measure approximately 90.5mm center to center, from one hole to another (3.57")
The "Large Pattern" bolt holes measure approximately 99.5mm center to center, from one hole to another (3.91")
|
|
|
3.5 inch driveshaft 
