Fuel Injector Cleaning and Testing. Driftmotion is now offering fuel injector servicing, done in-house on top of the line equipment. The pricing you see is for ONE injector, please order the correct number for how many injectors you will be sending in. We can do any type of gasoline or E85 fuel injector, even injectors from direct injection engines. Injectors sent in will be cleaned on the outside, and then checked for flow pattern, flow volume at static output (43psi), and pulsed at 2500rpm and 6000rpm, resistance will also be checked. A sheet detailing all the test results will be included. That would conclude the job if you only require testing. Please keep in mind that we can not "balance" or "match" injectors unless you send in multiple sets. Injectors can sometimes be cleaned for some additional time to try to improve flow if it is lower then it should be, but we can not make an injector flow more then it was intended to from the factory.
If we do a full service on your injectors, we would then take the injectors out of the testing machine and do an ultrasonic cleaning on them. The filter screens on top feed injectors will be removed and replaced with new ones. If the injector has pintle caps, those will be replaced with new ones. We will also install a new set of o-rings on your 14mm, 11mm, or side feed injectors. Side feed injectors cost a little more because new cushion rings are included also. The ultrasonic cleaning process will usually remove any paint or plating on the injector body, so we will either polish or paint the body to make them look nice again. We will then reinstall them in the testing machine and run all the tests again, and a sheet detailing all the test results will be included.
Please purchase this service on our website, and put a copy of the invoice in the box with your injectors. Shipping the fuel injectors to us is up to you, but please only use a service that offers tracking and signature confirmation. The shipping you pay for at checkout is the return shipping once the service is finished, and we will insure them for $50 each.
Be sure that any gas in the injectors is drained out, you can lightly spray them with compressed air if needed. Please wrap each injector in a paper towel, and put them in individual zip-lock bags. Then put them in bubble wrap in a good box, to avoid any damage in shipping. Send the injectors to: Driftmotion, 8975 Vernon Ave, Unit D, Montclair, CA 91763
Worth the money 
