Radium Fuel Pump Hanger, Toyota Supra MKIV
The Radium Engineering fuel pump hanger permits the use of 1, 2, or 3 Walbro 450 or 525 pumps in the stock MK4 Toyota Supra (JZA80) fuel tank.
To simplify aftermarket -AN hose plumbing, the 10AN ORB threaded feed port features a low profile 8AN male fitting and the 8AN ORB threaded return port features a low profile 6AN male fitting. To reconnect the OEM return and vent hoses, 8.5mm barb fittings are also included. Furthermore, no permanent modification to the OEM fuel tank access cover is required.
The custom designed stainless electrical studs easily handles the high current demand that compact bulkhead connectors lack. These serviceable connections are properly sealed and impervious to all standard and exotic fuels. The low profile design keeps all wiring tucked nicely underneath the OEM fuel tank cover using the provided foam insulation. Nylon acorn nuts are provided to prevent any accidental short circuits. Furthermore, the high quality in-tank wiring is insulated with chemically resistant PTFE. Electrical hardware is included for the fuel pump(s), OEM level sender, and OEM temperature sensor.
One issue with all Supra fuel pump hangers is the lack of fuel starvation protection. In this kit, the flow from the FPR return line powers a Radium jet pump. Using a venturi-effect, this "mechanical" pump draws fuel from outside the sub-tank and distributes it directly to the pump inlets.
A bespoke stainless steel triple pump mesh strainer is included for proper fuel pump inlet filtration.
Single pump applications can reuse the OEM fuel pump controller wiring, but it is recommended to upgrade the OEM wiring as these high flow fuel pumps draw additional current requiring larger gauge wire. Fuel pump wiring kits can be purchased HERE. Select qty1 for single pump applications, qty2 for dual pump applications, and qty3 for triple pump applications.
Features
-Drop-In OEM Replacement
-Permits 1-3 Fuel Pumps
-8AN Male Pump Outlet
-6AN Male Return Inlet
-Fuel Starvation Protection
-High Current Electrical Hardware
-Compatible with Various Pumps
-Anodized Aluminum Construction
Notes:
When purchasing this kit from Driftmotion as "No Pumps Included", the kit will come pre-assembled without pumps, and there will be enough components included to use 1 or 2 or 3 Walbro 450/525 fuel pumps. Depending on the setup, some parts will simply not be used. If you add the option for us to include fuel pump/s, you will need to install them in the hanger. The pumps will not include the normal Walbro installation kits (filter sock and connector), because it isn't needed with this Radium hanger kit.
